Stylish Wall Tile Panel In A Diamond Pattern

Author: | Categories: Wall Tile comments
Wall Tile Panel Design

Wall tile panel – Most wall tile panel treatments use a grid-like tile pattern with tiles placed as squares in rows and columns, covering the surface. When you turn on the grid 45 degrees, though, you can create a diamond pattern in which your tiles rise up against the wall at the points on the tiles in place on the flat. Laying your wall tile panel in a diamond pattern is not as difficult as it may seem. It’s mostly a matter of planning and careful placement to ensure that the tiles run straight.

Turn off the power leads to the tiled area by tilting the marked circuits in your home electrical panel. Remove any wall mount with a screwdriver, including electric socket covers that will disturb the location of the tiles. Clean the wall with a pH-neutral detergent, a sponge for general cleaning and a scrub brush to remove ground in dirt.  Sand the wall with 80-grit sandpaper to rough up the surface, creating texture more suitable for the application of mastic adhesive for your wall tile panel.

RELATED :   Italian Wall Tiles

Place the first cut tile on the horizontal guideline at the bottom of the tile surface in the center vertical line. Place full size tiles in the diagonal valleys created by the half tiles to use tile spacers create a uniform diagonal grout lines between tiles. Place full size tiles, using the same process as the first row of tiles to promote diamond effect until you reach the top row of tiles. Applying the grout to the joints between the tiles by means of a grout flow. Wipe off excess grout with a damp sponge within 15 minutes grout placement to prevent grout from hardening on the wall tile panel themselves. Place a bead of caulk in the border since moisture-rich surfaces instead of grout, for an extra measure of protection water. Replace the fixtures on the wall and restore power from the electrical panel.

Comments are closed.