Postmaster Fence Post – If you want your wire mesh fence to hold for a long time, then the correct installation of the messages is a must. It is important that the appearance and durability of the entire fence have the messages straight and level, not to mention stuck deep in the ground so it will never come out on its own. This project takes time to complete and is labor intensive.
Dig the hole for the posts. Once you have rethought the property of the fence and determine the placement of all your entries, you can start digging the holes for the terminal postmaster fence post. hollows of the posts of the stations should be 8 inches around and about 30 inches deep. The bottom of the hole must be wider than the top to anchor in the cement. Measure the height of the fabric fence and add two inches. Mark the messages from the top down with this measurement and mark the post with a colored pencil.
12 Photos Gallery of: Postmaster Fence Post Modern Design
The rest of the entry will be what is placed in the hole. Place the pole in the hole and center. Use a postmaster fence post level and get the lead plumb. Pour into the concrete around the pole or a shovel into it, and then double check the plumb bob. Over fill the hole and slope down the concrete with a trowel to keep the water from accumulating around the pole.